ClearSonic
Sorber™
Sound
Absorbing Panel System
SORBER
improves the performance of the ClearSonic Panel by soaking
up reflected and direct sound. This stray sound, if not absorbed,
could cause the kit to sound more "roomy" than desired.
The use of both ClearSonic Panels and SORBER baffles provide
a complete, portable, and cost effective solution to excessive
noise problems.
SORBER makes
a great stand-alone acoustic absorption "gobo" for
general stage and studio use.
Set up S5-2
SORBER in freestand mode (shown above) and avoid messing up
your walls by gluing, nailing, screwing, etc. Reconfigure your
room setup quickly and easily. Also, SORBER case fabric is "Velcro
receptive". If desired, SORBER can be held against a surface
using standard Velcro hook. S2 SORBER squares attach to ClearSonic
Panels this way. |
 |
Low Cost
- Portable
- Effective!
The
S2 Sorber Squares (shown above on A5-5 ClearSonic Panels) are
a 22" by 24" section of similarly encased fiberglass
that can be used in many applications. S2 can be used on the
lower half of the CSP to cut reflections, or used as wall treatment
for studios, basements, church sanctuaries, etc. The squares
are applied using small velcro patches for easy installation.
|
Northampton, MA 01062 
